Fujitsu FUTRO S900 - Removing the SmartCard Reader

System expansio ns English - 25
Removing the SmartCard reader
SmartCardr eader
► Open the casing (see "Opening the casing", Page 20 - English).
► If a PCI or PCIe board is installed, remove the cross piece and PCI or PCIe
board (see "
Removing the board", Page 38 - English).
1
2
4
3
3
► Disconnect the cable from the SmartCard reader (1) and from the mainboa rd (2).
► Undo the screws (3).
► Lift the SmartCard reader from the carrier (4).
► Reinst all the cross piece and the P CI or PCIe board if necessary (see
"
Installing the board", Page 36 - English).
► Close the c asing (see "
Closing the c asing", Page 21 - English).
Ensure that cables are not trapped between the casing and the co mponents.
Fujitsu Technology Solutions 67