Fujitsu FUTRO S900 - Page 70

24 - English System expansions
3
4
1
2
2
► Place the SmartCard reader on the carrier with the component side f acing
downwards, in the direction of the arrow (1).
► Fasten the SmartCard reader onto the carrier with the screws (2).
► Connect the cable to the SmartCard reader (3) and to the connector o n the mainboard (4).
► R einstall the cross piece and the PCI or PCIe board if necessary (see
"
Install ing th e board", Page 36 - English).
► Close the casing (see "
Closing the c asing", Page 21 - Engl ish).
Make sure th at the ca bles are not trapped between the casing and the components.
66 Fujitsu Technology Solutions