34 - English System expansions
► Place the Power over Eth ernet mo dule in the casing with the component side
facing upwards (2). Ensure that it engages in the slot.
1
1
► Secure the Power over Ethernet module with the screws (1).
► R einstall the cross piece and the PCI or PCIe board if necessary (see
"
Install ing th e board", Page 36 - English).
► Close the casing (see "
Closing the c asing", Page 21 - Engl ish).
Make sure th at the ca bles are not trapped between the casing and the components.
76 Fujitsu Technology Solutions
To Next Page
Loading...
