To Next PageTo Next Page
Need help?Do you have a question about the Fujitsu INDOOR UNIT Duct Type and is the answer not in the manual?
General| Brand | Fujitsu |
|---|---|
| Model | INDOOR UNIT Duct Type |
| Category | Air Conditioner |
| Language | English |
Precautions for handling R410A refrigerant and potential hazards.
Identifies specialized tools required for R410A refrigerant systems.
Guidance on choosing a suitable and safe location for unit installation.
Details specific dimensional requirements for unit installation.
Method for installing unit with top service access.
Method for installing unit with bottom service access.
Considerations for maintenance access during installation.
General procedures for installing the indoor unit.
Guidelines for transporting the unit safely.
Instructions for properly installing the unit's hanging supports.
Procedure for adjusting the unit to ensure it is level.
Procedure for mounting ductwork to the unit.
Guidance on choosing appropriate pipe materials for the system.
Specifications and requirements for connecting pipes.
Detailed steps for creating flare connections on pipes.
Steps for performing flare connections on pipes.
Techniques for bending pipes without causing damage.
Detailed instructions for connecting pipes securely.
Guidelines for installing heat insulation on pipes.
Instructions for insulating pipe couplers.
Requirements for electrical connections and wiring.
General wiring methods and connection diagrams.
Diagrams illustrating various electrical connections.
Steps for physically installing the remote controller unit.
Instructions for setting DIP switches on the remote controller.
Procedure for turning on the unit's power.
General method for setting various operational functions.
Details on various function settings for the unit.
How to select the room temperature detection source.
How to connect multiple indoor units for group control.
Setting for fan operation delay after compressor stops.
Configuration for using two remote controllers.
Details on external input/output connections.
Installation of IR receiver and remote sensor.
