Removing and ins tallin g components
during servicing
Installing and removing memory
expansion
MemorymoduleMainmemoryRemovingmemorySystemexpan sionSystemexpansion
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter "Impor tant notes", Page 12.
The notebook must not be connected to the power supply during installation or removal
of m emory modules, see "
Preparing to remove components", Page 45.
Only use memory expansion modules that ha ve been approved for your
notebook (see "
Tec hnical data", Page 63).
Never use force when installing or removing a memory extension.
Make sure that foreign obje cts do not fall into the memory extension compartment.
You must open the service compartment to remove o r install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. T heref ore, be sure to observe the following:
Individual components c an become very hot during operation. Therefore, we
recommend th at you wait one hour after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk o f suffering burns!
As some compone nts are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on installing and removing b oards and component s", Page 44.
Removing the cover
1
1
1
1
1
2
1
► Remove the screws (1).
► Lift the cover off the notebook (2).
46 Fujitsu
To Next Page
Loading...
