Removing and ins tallin g components
during servicing
Attaching the cover
2
2
1
► Place th e cover in the correct mounting position (1).
If you remove m ore than one compo nent at the same time, keep the screws for the
individual components separately from each other and make sure that you use the
correct screws. If you install the wrong screws, components may be damaged.
► Tighten the screws (2).
Finishing component removal
After y ou h
ave removed or changed the system co m ponents as you required, please
prepare y
our device for operation again as follows:
► Turn the n
otebook the right way up ag ain and place it on a flat surface.
► R econnect the cables th at you disconnected before.
52 Fujitsu
To Next Page
Loading...
