32
Changing the Play Settings for DVDs
The status of DVDs to play may be
determined by the intention of software
designers. In that case, functions may not
work as operated, because Instant MyMedia
is played according to the contents of the disc
which the software designer intended. Refer
to the instruction manual for the DVD to be
played.
Changing the Region Code
Each playable region code is set to each DVD,
so it cannot be played if this code is not matched
with the region code of playing devices.
If you want to play DVDs with different region
codes, the region code of Instant MyMedia can
be changed.
The change to the region code can be
made up to 4 times. When changes to the
region code are made 4 times, the code
is fixed to the last one, disabling DVDs
having other region codes to be played.
Note that there is no way to change the
fixed region code.
Region codes can’t be changed while
playing DVDs. Press [Stop/Eject] first.
1. Press the [Menu] button to display the menu.
2. Confirm the current region code. The item
with a “O” attached on the left side is the
region code that is currently set.
3. Select a new region and press the [Enter]
button. Only the DVDs having the region code
newly set can be played.
Setting the Play Start Position
Set the position for starting the play of DVDs.
1. Press the [Menu] button to display the menu
and select Auto Resume from the list.
2. In the right column, select the setting you
would like and press the [Enter] button.
Start from the beginning: Play from the
start of the disc regardless of the position
where it was previously stopped.
Start from last position: Play from the
position where the disc was previously
stopped.
The change to the setting of auto resume
becomes effective after the notebook has
been powered off.
Changing a Language Used in Audio and
Captions
Audio and captions can be selected from multiple
languages depending on the DVD. To change a
language for audio/captions during the play, use
the [Audio] button on the remote control.
1. Press the [Menu] button to display the menu
and select Audio Language or Subtitle
Language from the list. The language for
audio can be changed if the “Audio
Language” is selected, and the language for
captions can be changed if the “Subtitle
Language” is selected.
2. Select a language you would like from the
right column and press the [Enter] button.
The change to the setting of audio languages
and subtitle languages becomes effective
after the notebook has been powered off.
LB_Topaz 04 (23-40) 2/3/05, 2:27 PM32
To Next Page
Loading...
