Security functions
Access rights of SmartCards
SmartCardSmartCardS martCard
A new SmartCard initially only has a preset PIN and PUK. Access rights and the customised
PIN and PUK are not assigned until the SmartCard is initialised. The SmartCard type
depends on the access rights assigned to the card, as described below:
• User SmartCard: starting the system, changing the P IN
• SuperUser SmartCard: starting the system, changes in BIOS Setup, changing the PIN
• Service SmartCard: changes in BIOS-Se t up,, cannot start the operating system
• Admin SmartCard: starting the system, changes in BIOS Setup, changing the PIN,
uninstalling SystemLock, initialising SmartCards, blocking SmartCards
The following table shows a n overview of the rights granted with each type of
SmartCard when a PIN or PUK is ent ered:
User
SmartCard
SuperUser
SmartCard
Service
SmartCard
Admin
SmartCard
PIN PUK PIN PUK PIN PUK PIN PUK
Start-up system
xx x
Run BIOS Setup
xxx
Change own PIN
xx xxx
Unblocking own
blocked S martCard
x* x* x*
x
Unblock all b locked
SmartCards
x
Generating user cards
x
Uninstall SystemLock
x
* BIOS Setup setting (Unblock own SmartCard)
Usually there is always one Admin SmartCard and at least one User or SuperUser
SmartCard that will allow a system to be operate d.
72 Fujitsu Technology Solutions
To Next Page
Loading...
