Working w ith the notebook
Use the touch screen
You c an execute commands as follows:
• using the stylus pen (supplied with your device).
• using your fingers
Using fingers
You can execute certain commands by using your finger tip on the touchscreen of y our device.
Many things you can be select or activate using your finger tip can also
be selected or activated w ith the pen.
► To co nfigure the touchscreen for finger input, go to Settings in Windows
and select Bluetooth & devices - Touch.
Exit power-saving mode under Windows 11 by touching it with your fi nger
If th e device is in po wer-saving m ode, you can reactivate it by double-tapping
the touchscreen with your finger.
► Select this mode from Settings - Bluetooth & devices - Touch - Touch the screen to wake .
Activating this setting, especially when used as a tablet PC with the
screen flipped down, can cause the device to un intention ally return from
power-saving mode due to accidental finger touches.
If this setting is activated, it may result in higher power consumption in power-saving
mode.
Calibrate screen for touch
For information on how to calibrate your device to use the touch screen,
refer to the chapter "
Calibrating th e pen", Page 33.
Please note: There are separat e calibration programs available for calibrating the
stylus pen and for calibrating finger-based operation. Do no t use the calibration
tool for the stylus pen to calibrate finger-based operation.
Fujitsu 29
To Next Page
Loading...
