Security functions
Password protection for booting of the operating system
With the s upervisor password you have set in the B IOS Setup Ut ility (see
section "
Assigning the supervisor and user passwords", Page 63), you can
also prevent starting of the operating system.
Operating system
Activating system protection
► Start the BIOS Setup U tility and go to the Security menu.
Operatingsystem
► Select the Password on Boot option and press the Enter key.
► Select the desired option (Disabled, First Boot or Every Boot) and press the Enter key
► Select the Save Changes & Exit option unde r Exit.
The n otebook reboots. You will be prompted t o enter your password (the supervisor password).
Deactivating system protection
► Start the BIOS Setup U tility and go to the Security menu.
Operatingsystem
► Select the Password on Boot option and press the Enter key.
► Select the Disabled option and press the Enter key.
If you do not want to change any other settings, you can exit BIOS Setup U tility .
► Select the Save Changes & Exit option unde r Exit.
The n otebook will reboot. The system is no longer password-protected.
Password protection for the drive
If a supervisor password has been assigned, a password for th e drive can
also be set in the Hard Disk Security menu.
The drive is protected by this password. Data from this drive can only be read into
another system if the correct password has been entered.
64 Fujitsu
To Next Page
Loading...
