● 6 - 2
The displays for the Paper and Abrasion counters are shown below:
Simultaneously press the and arrow buttons for at least 1 second, to switch to the Life counter
panel display as shown below:
NOTICE
When the counter value is 0, no number is displayed.
Counter
Function
Paper counter
When the
button is pressed
for at least 1 sec-
ond
The paper counter counts the number of scanned sheets from
the start of reading until Paper Empty or an error is detected.
The counter is automatically reset at the start of reading. The
counter is used for checking the number of the sheets scanned
in one batch.
When the
button is pressed
for at least 1 sec-
ond
This counter increments each time a document is scanned. It is
not initialized until the power is turned off. The counter can be
used, for example, for checking the number of sheets that have
been scanned in one day.
Abrasion counter The abrasion counter counts the accumulated number of scanned sheets. This
counter increments every 10 sheets. It is useful to check the cleaning cycle or the
parts replacement cycle. How to reset it is described in Chapter7 "SETUP MODE".
Life Counter Keeps a cumulative count of the number of scans made after shipping.
This counter increments by 1 after every 10 scans and may be used to estimate of
the device's remaining scan life.
Rea d y XXXXX
XXX
X
Abrasion counter
Paper counter
0
>
Rea d
*
XXXXXX
Life counter
0
>
y
Counter Display
To Next Page
Loading...
Need help?
General