Fujitsu MCJ3230AP - Table 2.3 Environmental and Power Requirements

Specifications
2-4 C156-E205-01EN
2.1.3 Environmental and power requirements
Table 2.3 lists the environmental and power requirements.
Table 2.3 Environmental and power requirements (1 of 2)
Item Specification
Power
requirements
Average +5 VDC±5%, 1.4 A (2.5 A Max.) (*1)
Ripple requirement 100mV P-P (DC-1 MHz)
Ready (active mode) 4.3 W (typical) (*2)
Random seek, read/ write 5.6 W (typical) (*2)
Physical Format 7.0 W (typical) (*2)
Power
consumption
(Average)
Power save mode
Pre-idle mode
Idle mode
Standby mode
Sleep mode
3.8 W (typical) (*2)
1.3 W (typical) (*2)
0.7 W (typical) (*2)
0.7 W (typical) (*2)
With panel
101.6 # 150.0 # 25.4 mm
Dimensions
(W#D#H)
Without panel
101.6 # 148.4 # 25.4 mm
Weight 480 g (with panel)
Environmental
requirements
Operating Temperature: 5 to 45°C (*3)
(gradient 15°C /h or less)
Relative humidity: 10 to 85% (Noncondensing)
Max. wet bulb temperature: 29°C or lower
Non Operating Temperature: 0 to 50°C
Relative humidity: 10 to 85% (Noncondensing)
Max. wet bulb temperature: 36°C or lower
Transport Temperature: -40 to 60°C (24 hours or less)
Temperature: -20 to 60°C (24 hours or more)
Relative humidity: 5 to 90% (Non condensing)
Max. wet bulb temperature: 41°C or lower
Installation Tilt angle -5° to +10° (*3)
Vibration/
shock
Operating 3.9 m/s
2
(5 to 500 Hz, sine sweep)
1.96 m/s
2
(5 to 500 Hz, sine sweep AV record/play)
Shock 19.6 m/s
2
(10ms, half-sine pulse)
Non Operating
No cartridge, power ON
9.8 m/s
2
(5 to 500 Hz, sine sweep)
Shock 49 m/s
2
(10 ms, half-sine pulse)
Transport Shock 490 m/s
2
(10 ms, half-sine pulse)
Requirement: Packing conditions specified by
Fujitsu