BX920 S2 Options Guide 13
2Procedure
V CAUTION!
● The activities described in this manual must be performed by
engineers, service personnel or technical specialists.
● Equipment repairs must be performed by qualified staff.
● Any failure to observe the guidelines in this manual, and any
unauthorized opening or improper repairs could endanger the user
(through electric shock, fire hazards) or damage the equipment.
● Please note that any unauthorized opening of the device will result in
the invalidation of the warranty and exclusion from all liability.
Ê First of all, carefully read the safety instructions in chapter "Safety
instructions" on page 15 and following.
Ê Make sure that you have all necessary manuals (see "Documentation
overview" on page 9); print out the PDF files if required.
Most importantly, you will need the operating manual for the server blade.
Ê Shut down the server blade properly, switch it off, and remove it from the
system unit as described in chapter "Preparation" on page 19.
Ê Carry out the expansion or upgrade of your server blade as described in the
pertinent chapter.
I Installation and removal of hot-plug components is described in the
server blade operating manual.
Ê Close the server blade, re-insert it in the system unit and switch it on as
described in chapter "Completion" on page 67 and following.
Ê Start the operating system and make the appropriate configuration if
necessary (see operating manual).
To Next Page
Loading...
