52 Options Guide BX920 S2
SAS RAID Controller
Connecting the cables
Figure 29: Connecting the cables to the SAS RAID mezzanine card
– Plug the SGPIO cable into the "SDB" connector on the SAS RAID
mezzanine card (1).
– Plug the SAS cable #2 (gray) into the "SAS1" connector on the SAS RAID
mezzanine card (2).
– Plug the SAS cable #1 (red) into the "SAS0" connector on the SAS RAID
mezzanine card (3).
– Install the mezzanine card holder in the server blade as described on
page 47.
/
0 1
To Next Page
Loading...
