Fujitsu Primergy RX100 S3 Service Supplement

RX100 S3 Service Supplement 29
Replacement routines Replacing the system board
4.8 Replacing the system board
The PRIMERGY RX100 S3 server’s chassis ID is stored on both the LED board
and the system board. If in the event of failure, the LED board or the system
board which has to be replaced must have the chassis ID rewritten.
Ê Open the server as described in the section “Preparation” on page 17.
Ê Remove all external cables.
Ê Remove the riser card holder with the installed controllers (for a description
see the Options Guide).
Ê Remove the processor (for a description see section “Replacing the
processor” on page 25).
Ê Remove the memory modules (for a description see the Options Guide).
Ê Remove all cables which may be connected to the system board.

Fujitsu Primergy RX100 S3 Specifications

General

Brand	Fujitsu
Model	Primergy RX100 S3
Category	Server
Language	English