Fujitsu PRIMERGY RX100 S8 - Using the Cable Clamps (Hot-Plug PSU)

RX100 S8 Operating Manual 55
Hardware installation
5.4.2 Using the cable clamps (hot-plug PSU)
You can secure the power cords in cable clamps to ensure that the insulated
connectors cannot be disconnected from the server accidentally.
Figure 5: Using cable clamps
Ê Pull the cable clamp up (1).
Ê Thread the power cord through the cable clamp (2).
Ê Press the cable clamp down until it engages to secure the cable (3).