RX100 S8
Operating Manual 69
Starting up and operation
Ê Follow the on-screen instructions (see also section "Configuring the
server and installing the operating system with the ServerView
Installation Manager" on page 72 or section "Configuring the server and
installing the operating system without the ServerView Installation
Manager" on page 73).
– System already installed:
Ê Press the On/Off button (see figure 6 on page 59).
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
The power-on indicator lights up green (see figure 6 on page 59).
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
AC connected indicator lights up green.
I If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S4, you can configure
that the server is switched on/off controlled by timer.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
TM
).
– After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS or in iRMC S4).
To Next Page
Loading...
Need help?
General