Fujitsu PRIMERGY RX1330 M4 User Manual

RX1330 M4 Operating Manual 91
Troubleshooting and tips
Temperature warning
A temperature warning is output to the hardware event log and OS event log, or
ServerView issues a notification of a temperature warning such as by a popup
message.
This warning is issued by ServerView when the ambient temperature exceeds
the upper limit of the temperature boundaries. The upper limit is 35°C for
standard server and 40°C or 45°C with Advanced Thermal Design.
Added drive reported as defective
Cause Troubleshooting
The ambient
temperature exceeds
the upper limit of the
temperature
boundaries
Ê Although continued use within the temperature
boundaries poses no problems within itself,
reconsider the surrounding environment
conditions if this log is output or if ServerView
issues this notification.
Cause Troubleshooting
RAID controller is not
configured for this
drive
The drive was probably installed when the system
was switched off.
Ê Reconfigure the RAID controller for the drive
using the corresponding utility. Information is
provided in the documentation for the RAID
controller.
or
Ê Remove and reinstall the drive while the system is
switched on.
If the HDD/SSD continues to be shown as
defective, then replace it (see the "FUJITSU
Server PRIMERGY RX1330 M4 Server Upgrade
and Maintenance Manual").

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller