Fujitsu PRIMERGY RX900 S2 - Handling HDD and SSD Memory Modules

108 Operating Manual RX900 S2
CSS components
● Do not use the unit in extremely hot or cold locations, or locations with
extreme temperature changes.
● Never attempt to disassemble the hard disk/solid state unit.
9.3.1 Handling HDD and SSD memory modules
Hard disk drives/solid state drive incorporated in the HDD/SSD modules are
highly sensitive electromagnetic devices and must be handled with great care.
Incorrect handling can cause partial or total failure of the hard disk drives/solid
state drives. These failures can result in data errors and a loss of data or total
corruption of the hard disk drive/solid state drive.
Observe the following rules to prevent such problems occurring:
● Only store and transport HDD/SSD modules within the limits stipulated in the
specification.
● When transporting HDD/SSD modules (even over short distances), always
use the original packaging (ESD label).
● Never expose HDD/SSD modules to a temperature shock. Avoid the
formation of condensation inside and on the outside of the hard disk
drive/solid state drive.
V CAUTION!
The HDD/SSD module must be acclimatized in its operating
environment for an acclimatization time before it is started up for the
first time.
Temperature difference (°C)
(operating environment/
outside)
Minimum acclimatization time
(hours)
53
10 5
15 7
20 8
25 9
30 10
Table 4: Acclimatization times for HDD modules