Fujitsu PRIMERGY RX900 S2 - Connecting the Power Cord

74 Operating Manual RX900 S2
Hardware installation
5.4.1 Connecting the power cord
Figure 13: Connecting the power cord
Ê Connect the power cord to the server power supply unit (1).
Ê Thread the cable through the cable clamp and pull the cable clamp tight to
secure the power cord (2).
Now the insulated connector cannot be disconnected from the server
accidentally.
I You can loosen the cable clamp by opening the small locking lever.
Ê Connect the power plug to a grounded power outlet in the in-house power
supply network or a power outlet of the socket strip in the rack, see Technical
manual for the rack.
/
0