EasyManua.ls Logo

Fujitsu PRIMERGY RX900 S2 - HDD;SSD Module and Dummy Module

Fujitsu PRIMERGY RX900 S2
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RX900 S2 Operating Manual 109
CSS components
Always set the HDD/SSD module down carefully, with the large surface
facing downwards to prevent it from tipping over.
9.3.2 HDD/SSD module and dummy module
Figure 21: 2.5-inch HDD/SSD module and dummy module
1 Dummy module
2 Tabs for unlocking the dummy module
3 HDD/SSD module (installation frame with hard disk drive/solid state drive
installed)
NOT DEFINED shows a hard disk drive. Solid state drives are installed in
the same installation frame.
4 Indicators
HDD/SSD Busy (LED green)
HDD/SSD Fault (LED orange)
For description see section "Indicators on the hot-plug HDD/SSD
modules" on page 82.
5 Handle for locking and unlocking the HDD/SSD module
6 Button for locking and unlocking the handle
7 Ridge for applying a sticker with the current drive name and drive size
/0 1 2345
0

Table of Contents

Other manuals for Fujitsu PRIMERGY RX900 S2

Related product manuals