RX900 S2 Operating Manual 79
Starting up and operation
6.1.1.3 Indicators on the control panel
On/Off button
When the system is switched off, it can be switched on again by
pressing the On/Off button.
When the system is operating, pressing the On/Off button will
switch off the system.
V CAUTION!
Risk of loss of data!
I The On/Off button does not disconnect the server from the
mains voltage. To disconnect from the mains completely,
remove the power plug(s).
RST Reset button
Pressing the reset button reboots the system.
V CAUTION!
Risk of loss of data!
NMI NMI button
V CAUTION!
Do not press! Risk of loss of data! The NMI button may only
be used by service.
ID ID indicator (blue)
– Lights up blue when the system has been selected by
pressing the ID button. To deactivate, press the button again.
– Flashes blue when the BMC is in emergency mode.
The ID indicator can also be activated via the ServerView
Operations Manager and the iRMC S2 Web interface and its
status reported to the ServerView Operations Manager and the
iRMC S2.
To Next Page
Loading...
