RX900 S2 Operating Manual 91
Starting up and operation
6.3 Configuring the server
This section contains information about configuring the server and installing the
operating system.
I Make sure that the energy saving functions are disabled in the BIOS
Setup during server operation.
6.3.1 Configuring the SAS RAID controller
The server has a SAS RAID controller with "Integrated Mirroring Enhanced"
functionality or "MegaRAID functionality". You can configure the SAS RAID
controller either before or during installation with the ServerView Installation
Manager. Using the ServerView Installation Manager is recommended.
I The controller makes a separate utility available for IME configuration.
For further information, refer to the "Integrated RAID for SAS User’s
Guide" (on the ServerView Suite DVD 2 under Industry Standard Servers -
Expansion Cards - Storage Adapters - LSI RAID / SCSI Controllers).
A separate utility is available to the controller for MegaRAID
configuration. For further information, refer to the "SAS Software User’s
Guide" (on the ServerView Suite DVD 2 under Industry Standard Servers -
Expansion Cards - Storage Adapters - LSI Configuration Software).
Further information on modular RAID controllers is provided in the
"Modular RAID Controller Installation Guide" (on the ServerView Suite
DVD 2 under Industry Standard Servers - Expansion Cards - Storage Adapters
- LSI RAID / SCSI Controllers).
I Descriptions of operating systems not covered in the controller manual
are provided in the corresponding readme files on the driver CDs.
To Next Page
Loading...
