ScanSnap S510M Operator's Guide xvii
Unplug the power cord from the electrical outlet when the
scanner is not used for an extended period of time.
Before moving the scanner, unplug the power cord from the
electrical outlet.
Avoid any contact when scanner is working.
Do not use aerosol sprays near the scanner.
For your safety, unplug the power cord from the electrical outlet when the
scanner is not used for an extended period of time.
Do not move the scanner with the power and interface cables connected as this
might damage the cables, causing fire, electric shock or injuries.
Before moving the scanner, be sure to disconnect the power plug from the power
outlet, and disconnect data cables. Also, make sure that the floor is free of
obstructions.
Avoid getting a sleeve, necktie, or hair caught up in any scanner mechanism
when scanning as this may cause injuries.
Do not use any aerosol sprays or alcohol based sprays to clean the scanner.
Dust blown up by strong air from the spray may enter the inside of the scanner.
This may cause the scanner to fail or malfunction.
Sparks, caused by static electricity, generated when blowing off dust and dirt from
the outside of the scanner may cause a fire.
To Next Page
Loading...
Need help?
General