210
• Plastic rollers (4 pieces on the ADF)
Clean them lightly while rotating the rollers with your finger. Be careful not to roughen the
surface of the rollers. Take particular care in cleaning the plastic rollers since black debris
on the rollers adversely affects the pickup performance.
T
urn on the ScanSnap before cleaning the following locations, and rotate the rollers to clean
them thoroughly.
• Feed rollers (2 pieces)
Clean lightly taking care not to roughen the surface of the rollers. Take particular care in
cleaning the feed rollers since black debris on the rollers adversely affect the pickup
performance.
• Eject rollers (2 pieces)
Clean lightly taking care not to roughen the surface of the rollers.
Take particular care in cleaning the eject rollers since black debris on the rollers adversely
affect the pickup performance.
To rotate the feed rollers and the eject rollers, press the [POWER] button while holding
down the [SCAN] button.
As a guideline, six presses of the [POWER] button make the rollers to rotate one full turn.
Connect the power cable only when cleaning the feed rollers and eject rollers.
1. Hold down the [SCAN] button.
2. Press the [POWER] button
while holding down the [SCAN]
button.
⇒ The rollers rotate.
To Next Page
Loading...
