22
2. Connect the USB cable to the USB connector on the ScanSnap, and the other end of
the USB cable into the USB port on your computer.
Insert the USB cable into the connector all the way to the end.
3. Open the paper chute of the ScanSnap.
⇒ ScanSnap is automatically turned on and detected by your computer.
HINT
It may take some time for the ScanSnap Manager icon on the Dock menu to
become .
If you have waited for some time, and it still remains as , turn off the
power using the ScanSnap [POWER] button and turn on the power again.