Fujitsu SCENIC S - Installing;Removing a Smartcard Reader

System expansions
44 A26361-K523-Z100-6-7619
Installing/removing a SmartCard reader
Ê Open the casing (see "Opening the casing“).
Ê Remove the holder for the SmartCard reader and the compact flash board (see "Installing the
compact flash board").
Installing a SmartCard reader
Ê Push the SmartCard reader board into the carrier guide rail with the underside facing the panel.
Ê Fasten the board into place with the screws.
2
Ê Fix the cable on the SmartCard reader and on the connector for the SmartCard reader on the
system board (see the Technical Manual of the system board).
Ê Install the holder for the SmartCard reader and the compact flash board (see "Installing the
compact flash board").
i
With the SmartCard reader connected, no devices may be connected to serial
port 2.
Ê Close the casing (see "Closing the casing“).
Removing a SmartCard reader
1
Ê Pull the cable off the SmartCard reader and off the connector for the SmartCard reader on the
system board (see the Technical Manual of the system board).
Ê Loosen the screws (1).
Ê Remove the SmartCard reader from the holder guides in the direction of the arrow (2).