FCC and IC Regulatory Inf ormation
Federal Communications Commission and Industry
Canada statement:
This device complies with Part 15 of FCC Rules and Industry Canada license exempt RSS standard(s).
Operation is s ubject to the following two conditions: (1) This device may not cause
interference, and, (2) This device mu st accept any interference, including interference
that may cause undesired operation of this device.
Déclaration d’Industrie Canada
This device complies with Indu stry Canada’s license-exempt devices and RSS standards
for Internet updates. Ce t appareil est conforme à la RSS concernant les appareils exempts
de licence par Ind ustrie Canada. Its operation is subject to the following t wo conditions:
Son fonctionnement est soumis aux deux conditions suivantes : (1) This device may not
cause harmful interference; (2) this device must accept an y interfe rence receive d, including
interference that may cause undesired operation. (1) cet appareil ne doit pas causer
d’interférence nuisible; (2) cet appareil doit accepter toutes les interférences reçues, y
compris celles pouvant causer un mauvais fonctionnement de l’appareil.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, p ursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio comm unications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment d oes cause harmful interference to radio or television reception, w hich
can be determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
Fujitsu 91
To Next Page
Loading...
Need help?
General