Split system (Single phase and 3-phase type)
Maintenance Document 1544-1 99
6.1.10 EEV COIL removal
MAIN
INJECTION
6.1.11 PRESSURE SENSOR removal
> Warning ! <
Wear gloves to prevent the frostbite, because a
small amount of refrigerant leaks during work.
Remove the EEV coil by hand.
Remove the EEV coil by hand.
Remove the PRESSURE SENSOR
with wrench.
Note the tightening at the installation.
Tightening torque is 12+-1.5N.m.
Single Phase type
To Next Page
Loading...
