FT-C Vertical Electric Thermal Fluid Heater Manual 12 2013 ISSUE 1
General 1.1
Technical Data (Heat Output) 1.2
General 2.1
Transport 2.2
Siting 2.3
Gas & Oil Supply 2.4
Oil Supply 2.5
Access 2.6
Minimum Clearance for Coil Removal 2.6.1
System Connections 2.7
Drain/Fill Connection 2.7.1
Heater Connections 2.7.2
Electrical Connections 2.7.3
Voltage and Frequency 2.7.3.1
Pipework Systems 2.8
Combination Expansion/Deaerator/Thermal Buffer Tank 2.9
Expansion Section 2.9.1
Deaerator Section 2.9.2
Thermal Buffer Section 2.9.3
Sizing the Tank for the System 2.9.4
Location 2.9.5
Pressurised Systems 2.9.6
Connections 2.9.7
Oil and Gas Circulating Pump 2.10
Location 2.10.1
Connections and Piping 2.10.2
Alignment 2.10.3
Lubrication 2.10.4
Seals 2.10.5
Air Cooling 2.10.6
Water Cooling 2.10.7
Catch Tank 2.11
Gauges 2.12
Valves 2.13
Piping 2.14
Gasket Installation Instructions 2.15
Testing 2.16
Insulation 2.17
Thermal Fluids 2.18
Thermal Fluids at Elevated Temperatures 2.18.1
Selecting a Thermal Fluid 2.18.2
Routine Analysis of Heat Transfer Liquid 2.18.3
Thermal Fluid Breakdown 2.18.4
Multi-Skid Systems 2.19
General 3.1
Start-Up Preparation and Installation Review 3.2
Filling the System 3.3
Filling Procedure 3.3.1
For Systems Equipped with Inert Blankets 3.4
Circulating Pump 3.5
Mechanical/Air Cooled Seal 3.5.1
To Next Page
Loading...
