EVO EXPERT Manual 35/105
Change the active field with the ‘►’ key and introduce the desired value in each field using the ‘’
and ‘’ arrows. Hit the ‘ENTER’ key to accept the value. Hitting ‘ENTER’ again with the ‘SAVE’
option highlighted saves the changes and these will be saved until the next modification by the
same procedure. If we deactivate the ‘TTS’ option, the value will remain saved in the memory.
The exit keys ‘MEM/CLEAR’ and the ‘◄’ key continue to fulfil their traditional functions, bring us to
the main menu screens or the previous screen, respectively. With the ‘MEM/CLEAR’ key, the
changes will go unsaved. Moreover, the key ‘ON’ brings us to ‘MEASURE CONFIGURATION’ screen.
NOTE: It is impossible to select both the TTT and TTS functions at the same
time.
8.4.1.1.2 Storage
If you choose the Storage option you will be activating experiment recording or recording
measurements in the memory test profile. For this, you will be led to the following screen:
The default mode is ‘OFF’. To activate this option, use the ‘ENTER’ key to turn it ‘ON’ and vice
versa.
While the option is deactivated (‘OFF’), we cannot select the time fields that regulate this function.
INIT: record start time.
END: data record end time.
INCREMENT: the increments by which samples are taken.
Once the field in active, you can select different fields, jumping for one to another using the ‘’ and
‘’ arrows. To modify each field, press ‘ENTER’. A screen such as the following will appear:
The selected field will highlight its background on the screen while it is modified, using the ‘’ and
‘’ arrows and introducing the desired values in the digital places this way. Upon digit entry the
viscometer will jump to the next digit place by pressing the ‘ENTER’ key. To save the changes press
‘ENTER’ again with the ‘SAVE’ option highlighted, which will unselected the fields and save the
values entered.
To Next Page
Loading...
Need help?
General
