EVO EXPERT Manual 47/105
As it can be seen, a box with some information appears on the bottom area of the screen. On the
left side the ‘MULTISTEP’ text is shown. Moreover, the central area of the box shows and counts
down the remaining time of the step under execution. Furthermore, on the right side it is shown the
step under execution from the total of the steps.
When the application is finished, the following screen will appear (example):
The countdown is replaced by the ‘END PROGRAM’ text.
By pressing the ‘MEM/CLEAR’ key you’ll be brought to the viscometer’s main menu screen.
8.5.4 Ramp
The RAMP application is one of the many options offered in the ‘PROGRAM’ menu of the Fungilab
Evo EXPERT viscometers. This application allows us to program the viscometer to increase linearly
the spindle turn speed in a determined time and with a positive speed graduation.
We select this option by pressing the ‘ENTER’ key with the ‘RAMP’ option highlighted on the
programming screen. The equipment will then show on the screen:
For the L models:
For the R and H models:
To Next Page
Loading...
Need help?
General
