EVO EXPERT Manual 46/105
For R and H models:
Here you can reconfigure all of the measurement parameters. The spindle to be used and the
density of the sample can be changed in this screen as it is explained above. The steps can also be
edited selecting the ‘STEP’ field with the ‘’ and ‘’ keys and pressing ‘ENTER’, as it is already
explained. Moreover, the execution of the experiment according to the programmed steps can be
started from this screen by pressing the ‘ON’ key.
NOTE: The ‘Multistep’ speeds do not have to be linear, or even follow a positive
graduation. The user can program any progression type (growing, decreasing,
rising and declining, etc.).
Using the ‘◄’ key you will return to the initial screen of ‘MULTISTEP’ programming. The
‘MEM/CLEAR’ key will bring you to the main menu without saving the changes.
It also can be started the execution of the measurement according to the MULTISTEP program from
the configuration screen, with the list of configured steps such as the listed in the following
example:
By pressing the ‘0N’ key, you start the measurements according to the programmed steps. If you
press the ‘0N’ key without having validated a step with the ‘ENTER’ key, the viscometer will not
keep it in memory and will proceed to measure without the non-confirmed step.
Here is a model of the following screen:
To Next Page
Loading...
Need help?
General
