EVO EXPERT Manual 38/105
By pressing the ‘ENTER’ key again, the test profile selection screen will reappear to be able to select
another test profile. The ‘MEM/CLEAR’ and ‘◄’ keys continue fulfilling their habitual functions by
carrying the user to the main menu screen o the previous screen, respectively.
NOTE: There exists a way to select the log through fast access. When the user
is on the main screen of the viscometer, the ‘MEM/CLEAR’ key can be hit and a
letter M will appear on the lower part of the screen giving this view:
When this M is on the screen the keyboard function has been activated, the
user can directly select one of the nine
“test profile”
. Press one of the nine keys
with a keyboard test profile
symbols (for example 3 M3). It takes the user
directly to the test profile
information screen and the user can proceed as was
explained before. In the same way, if an empty test profile
is selected (without
having been recorded on), it will show the empty slot screen.
8.5 Programming
The Programming menu contains the functions that allow some optional applications to be
programmed for the measurements. The TTT (Time to Torque), TTS (Time to Stop) and the Speed
Configuration are applications that are complementary to the normal measurements. Contrarily, the
options ‘Ramp’ and ‘Multistep’ are applications, which function independently of the ordinary
measurements. These run through the normal programming of the viscometer.
From the main menu screen you must highlight the option “Program”, as seen in the following
diagram:
To Next Page
Loading...
Need help?
General
