1. MOUNTING
1-7
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
• A magnetic compass will be affected if the processor unit is placed too close to the
magnetic compass. Observe the compass safe distances in the "SAFETY
INSTRUCTIONS" on page i to prevent interference to a magnetic compass.
• For the mounting direction, the cable entry must face downward.
• Referring to the weight of this unit, indicated in the outline drawings at the back of
this manual, reinforce the mounting location if necessary.
1.3.2 How to install the transceiver unit
Use M6 (supplied) or M8 (local supplied) screws. Note that the size of mounting holes
differ according to the screw size.
Note:
For bulkhead installations, the cable entry must face downward.
1. Make four pilot holes, referring to the outline drawing at the back of this manual.
2. Fit two self-tapping screws at the location for
the bottom fixing holes. Leave approximately 5
mm of thread exposed. The mounting holes
and notches differ according to the mounting
screws.
3. Place the transceiver unit on the two screws
and fasten two self-tapping screws to the top
fixing holes.
4. Fasten the two self-tapping screws at the bot-
tom fixing holes tightly.
Grounding
Ground the unit with the supplied ground wire referring to the figure below.
Top view
Mounting holes
(M8䠅
Mounting holes
(M6䠅
Notch
Gounrd terminal
CAUTION
Ground the equipment
to prevent electrical
shock and mutual
interference.
To Next Page
Loading...
