What to do if Furuno DSC-60 power cannot be turned on?
If your Furuno Marine Equipment won't power on, several factors could be at play. First, ensure the mains switchboard is turned on. Next, check the supply voltage, as DC overvoltage input could be the issue. Lastly, the battery may be discharged or have poor contact at the terminals; in this case, recharge the battery and tighten the battery terminals.
Why is there no sound from the loudspeaker on my Furuno DSC-60 Marine Equipment?
If your Furuno Marine Equipment has power but no sound is coming from the loudspeaker, the loudspeaker may be off. To resolve this, operate the [7/ ] key to turn on the loudspeaker.
How to fix Furuno DSC-60 Marine Equipment display when key lamps are lit but there are no display indications?
If your Furuno Marine Equipment shows key lamps lit but no display indications, the contrast may be too low. Adjust the contrast by pressing the [9/ ] key followed by or to increase or decrease the contrast, respectively.
Introduces the two main test functions: DAILY TEST and Setup Menu tests.
Step-by-step guide for performing the daily test and troubleshooting "NG" results.
Covers on-board, factory, and performance tests accessed via the setup menu.
Details how to measure output signal frequency and power.
Describes the daily self-test, procedures, and troubleshooting for "NG" results.
Troubleshooting guide for various failures like power, NMEA, LCD, key operation, and sensitivity.
Instructions for updating the main and modem system programs using IB-581 or PC.
General| Display | LCD |
|---|---|
| Interface | NMEA0183 |
| Channel Spacing | 25 kHz |
| Operating Temperature | -15°C to +55°C |
| Category | Marine Radio |
| Dimensions | 83mm (H) x 178mm (W) x 131mm (D) |
| Operating Frequency | 156.025 - 157.425 MHz |
| Modulation | G3E (FM) |
| DSC Standard | ITU-R M.493-13 |
| Power Output | 1 W / 25 W |
To Next Page
