4-18
3.2 Setting for the connection with FS-75/1562/5000 and DP-6
TX/RX control data exchange between Furuno radio units are made normally by MIF protocol
through the RS-232C connections with factory-default setting.
When the interconnection cable is lengthened, select C. Loop by S4, instead of RS-232C and
MIF in the SYSTEM menu.
Connection with FS-5000 and DP-6
Connection with FS-75/1562 and DP-6
The DIP switches on CONTROL/MODEM board of DSC-60 are set as follows:
RT: Set S4. (Selection of data format for the communicatin with RT)
- S4-1 and 2 : ON (RS-232C); OFF (C. Loop)
- S4-3 and 4 : OFF (RS-232C); ON (C. Loop)
NBDP: Set S3. (Selection of data format for the communication with NBDP)
- S3-1 and 2 : ON (RS-232C); OFF (C. Loop)
- S3-3 and 4 : OFF (RS-232C); ON (C. Loop)
Note) Related settings
Pressing [#/SETUP] key reveals “Setup menu” screen. Select SYSTEM, and set RT
PORT and NBDP PORT.
- RT PORT ->>> MIF
- NBDP PORT ->>> ON
Furthermore, priority setting must be made on FS-75/1562 (not necessary on FS-5000). See
page 2-17.
When NBDP port is not used,When NBDP port is not used,
When NBDP port is not used,When NBDP port is not used,
When NBDP port is not used,
set set
set set
set
“NBDP”“NBDP”
“NBDP”“NBDP”
“NBDP”
of SYSTEM setting a of SYSTEM setting a
of SYSTEM setting a of SYSTEM setting a
of SYSTEM setting a
t OFFt OFF
t OFFt OFF
t OFF
. .
. .
.
DIP sDIP s
DIP sDIP s
DIP s
witcwitc
witcwitc
witc
h S3-#1 and #2 is set ah S3-#1 and #2 is set a
h S3-#1 and #2 is set ah S3-#1 and #2 is set a
h S3-#1 and #2 is set a
t ONt ON
t ONt ON
t ON
..
..
.
2. System setup(Setting DIP Swithes)
DSC-60
[RT]
[NBDP]
DP-6
DB-120
FS-75/1562
[REM]
[REM-B] [REM-A]
REM-A
PCB
#2-SD
#3-RD
#2-SD
#3-RD
DSC-60
[RT]
[NBDP]
DP-6
FS-5000C
[REM-1/2/3]
[REM-1/2/3]
[REM-B] [REM-A]
#2-SD
#3-RD
#2-SD
#3-RD
To Next Page
Loading...
