Furuno DSC-60 - Chapter 7 Maintenance; 1. Daily Test Procedures and Troubleshooting

7-1
Chapter 7 Maintenance
1.Daily test
Pressing [3/TEST/DEF] key with DSC standby screen or Radiotelephone setting screen automatically
starts the daily test, and the test results are displayed. Main CPU, MODEM, and RX board can be
checked, and the connection between MF/HF radiotelephone and NBDP made by Furuno Electric can
be checked by MIF commands.
1.1 Procedures
1. Press [3/TEST/DEF] key with DSC standby screen or Radiotelephone setting screen.
2. The test automatically starts. No canceling during self-test.
3. It takes 30 to 40 seconds to complete the test. Then, the distress alarm LED flashes, and the buzzer
and external speaker sounds for 2 seconds.
4. The test results are displayed.
If a printer is connected, pressing [8/PRINT/TUV] key can print out the results.
Note) The default setting of DAILY TEST in PRINT OUT submenu of “Setup menu” is set at
“MANUAL”. Set it at “AUTO” to print out the test results automatically.
The printed date and time is the data of NMEA data (ZDA) from the navaids.
5. Pressing [CANCEL] key returns the screen to DSC standby screen.
WATCH KEEPING
DISTRESS
ROUTINE
AUTO ACK
VOLUME
2187.5 4207.5 6312.0
16804.5 12577.0 8414.5
2177.0 4219.5 6331.0
16903.0 12657.0 8436.5
32
45 00.000N 135 00.000E 23:59
VOLUME 32
TX : 12 329.0 kHz
RX : 13 17600 kHz
POWER : HIGH
TUNE : NO TUNE
MODE : TELEPHONE
CH:12034
or
DSC standby screen RT setting screen
* * Complete test * *
MAIN CPU
MODEM
RCVR1
RCVR2
REMOTE RT
REMOTE DP
: OK VER.xx
: OK VER.xx
: OK
: OK
: OK FS-1562
: OK DP-6
* * Complete test * *
MAIN CPU
MODEM
RCVR1
RCVR2
REMOTE RT
REMOTE DP
: OK VER.xx
: OK VER.xx
: OK
: OK
: OK FS-1562
: OK DP-6
MMSI
: 123456789
JAN - 10 - 2000 - 15:26
* * Complete test * *
MAIN CPU
MODEM
RCVR1
RCVR2
REMOTE RT
REMOTE DP
:
:
:
:
:
: