4-8
2.4 Position setup
This item sets ON/OFF of position data acquisition.
Pressing [#/SETUP] key reveals “Setup menu” screen. Select POSITION, and press [ENT] key.
Then, the following “Position setup” screen appears.
1. INPUT 1. INPUT
1. INPUT 1. INPUT
1. INPUT
TYPE (DefTYPE (Def
TYPE (DefTYPE (Def
TYPE (Def
ault setting:ault setting:
ault setting:ault setting:
ault setting:
AA
AA
A
UTUT
UTUT
UT
O)O)
O)O)
O)
When navigational aids are connected, set this item at “AUTO”.
The position data and time data are combined with such messages as DISTRESS CALL, INDI-
VIDUAL CALL, and POSITION CALL. When this item is set at AUTO, the data from the connected
navigational aids is automatically taken in and displayed. The precedence order of NMEA data
acquisition sentences is “GGA, RMC, RMA, GLL, and ZDA”.
When this item is set at MANUAL, the position and time data are entered manually.
MANUAL data have precedence over AUTO data.
If AUTO or MANUAL input data are not updated for more than 23 hours and 30 minutes, these data
will be deleted from the message.
Note)Note)
Note)Note)
Note)
- When daily test results, transmitted messages, and received messages are automatically
printed out, the date and time included in NMEA data (Sentence:ZDA) are also printed.
If the ZDA is not received, regardless of the “INPUT TYPE” setting, date is not printed.
- If NMEA data is interrupted for more than one minute, “EPFS error” is displayed and the
buzzer and external speaker will sound.
Ref Ref
Ref Ref
Ref
erer
erer
er
ence) Relaence) Rela
ence) Relaence) Rela
ence) Rela
ted settingsted settings
ted settingsted settings
ted settings
The setting of DIP switch S5-4 on CONTROL/MODEM board depends on whether IEC-
61162-1 (NMEA) input terminal fits to RS-422 or Current Loop. Refer to Page 4-19.
2. System setup(POSITION)
* * Position setup * *
INPUT TYPE
LAT : --' -- NORTH
LOG
TIME
: ---' -- EAST
: -- : -- UTC
AUTO
MANUAL
: AUTO
J7
J6
J1
J3 J8 J9
J4
J5
U5 U11
S1
NMI SW
EEPROM
05P0702
S5
- S5-4 --> OFF : RS-422
- S5-4 --> ON : C.Loop
To Next Page
Loading...
