2. WIRING
2-13
After tightening the inner sheath by the gland, wind a grounding wire on the armor as
shown below. Then connect the grounding wire to the wing nut on the front of the chas-
sis.
2.6.2 How to connect the cables
For the cable connection details, see the interconnection diagram at the back of this
manual. After cable connection, seal the gland with putty for watertightness as shown
below.
Gland
Inside of the
junction box
Inner sheath
Outer sheath
Armor
rmor (for cable with no outer sheath)
Connect the crimp-on lug
to wing nut on the front
chassis.
Gasket
Wind the copper line of the
grounding wire (local supply).
123456789
10 1211
Copper
strap
Outer shield
Clamp vinyl
sheath by cable
gland.
After clamping cable, seal cable
gland with putty for watertightness.
Vinyl tape
Transducer
cable
Distributor
cable
After cable
connection
Grounding
terminal
Wind a copper
line on the
armor
To Next Page
Loading...
