1.4 List of Functions
1-21
Table 1.4.1 (2/5) List of Functions
Function Description Remarks
Zoom
Two times zoom/Three times zoom
Screen fixed/GND fixed/Target tracking
Zoomed area is marked by a box.
Brightness 100 steps Adjusted by the encoder.
Panel brightness 16 steps
Range scale nm/km/sm/kyd IMO, A type: nm
+ Cursor
Range and bearing Relative/Range and bearing
True/LL/X-Y/Fishing ground
Brightness in 16 steps.
Watch alarm IN/OUT
Pulse length
The pulse width determined by the selected
Range.
2nd Sweep Echo Reject OFF/ON
Blind sector setting
Maximum angle 135°in two areas
Presentation mode HU/HU-TB/CU/NU/TM
Display mode Radar/Rader + Plotter/Plotter B/C type only
Off Center OFF/ON
Desired position within 75% of
radius.
VRM
Two VRMs
** Unit of distance: nm/km/sm/kyd**
- Distance is continuously
changeable.
- Mark brightness in 16 steps
- IMO, A type: nm
EBL
Two EBLs
** Relative/true (Only True except for HU
and HU-TB modes) **
- Bearing is continuously
changeable.
- Mark brightness in 16 steps
Heading line Erased only while pressing the [HL OFF] key.
Mark brightness in 16 steps
Stern line Erased only while pressing the [HL OFF] key.
Mark brightness in 16 steps
Range ring Erased only while pressing the [HL OFF] key.
Mark brightness in 16 steps
Index line The bearing and range can be set.
Mark brightness in 16 steps
Own ship symbol
OFF/ON
Ship length, ship width, Rader and GPS antenna
position set in the INITIALIZE menu.
Mark brightness in 16 steps
BRILL BRILL1>BRILL2>BRILL3>BRILL4
Settable items:
ECHO COLOR/BKGD COLOR/
CHARACTER/CURSOR/ECHO/
TRAIL/HL/RING/
BEARING CURSOR/EBL/
VRM/INDEX LINE/
ARPA SYMBOL/
AIS SYMBOL/
LL GRID/MARK/CHART/
PANEL DIMMER
To Next Page
Loading...
