4.4
Initialize Setting
Initialize Setting Initialize Setting
Initialize Setting
4-30
4.4.11 OWN SHIP INFO
INITIALIZE -> 5
5 5
5
“2: LENGTH/WIDTH” data is used to draw the OWN SHIP MARK.
“3: SCANNER POSN” and “6: CONNING POSN” data determine the origin of a radar
graphic data. The figures below show the origin of range ring by the selection of [REF
POINT]. The graphic data, VRM, EBL, ARPA target, cursor and positioning of AIS
target mark are caluculated from the [REF POINT]. Selecting the “CONN POSN”,
those data coincides with the crew’s eye even if the scanner position is away from the
conning position.
“4, 5: GPS ANT POSN” data is used for L/L calculation of the cursor position on the
screen. The displayed position data in the [OS POSN] is the GPS antenna position.
Note:
“[INSTALLATION] -> 5: RADAR POSN” data is used for video signal processing of
echo trails and echo averages.
Fig. 4.4.11 SCANNER POSN and CONNING POSN View
CONNING POSN
SCANNER POSN
To Next Page
Loading...
