2. WIRING
14
2. Loosen four screws to open the fil-
ter cover.
3. Loosen or remove the cable entrance assembly as shown below.
To connect CN8, CN10, CN12 and CN13, remove the cap spacers from the cable
clamp.
4. There is a plastic sheet on the inside of the cable entrance. Before passing the
cables, tear the plastic sheet by hand to pass the cables.
5. Connect cables as shown below.
Top and front views of the Transceiver unit
Remove two screws.
Remove four screws.
Loosen two screws.
Cap spacer
Front view
Top view
CN4
CN2
CN3
CN6
CN9
CN12
CN8
CN11
CN14
CN5
CN7
CN10
CN13
CN1
Transceiver unit
To Next Page
Loading...
