6. SETTINGS ON WEB INTERFACE
6-41
6.8.8 How to setup a DMZ
A network DMZ (demilitarized zone) helps to provide a “buffer” of security between
your network (LAN, etc) and the internet.
Note: To setup a DMZ, [Group Type] must be set to other than [Bridge] or [PPoE].
You can setup a DMZ for your network with the following procedure.
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin], [Network Settings], [WAN], then [Groups].
3. Click the [Settings] button for the group whose IP filter you want to setup.
4. Click [DMZ].
5. Referring to the following table, set up DMZ according to your system.
6. Click the [Apply] button.
The message "Applied." appears.
7. Click the [Close] button to close the message.
Item Description
Enable/Disable Put a [9] in the box to use DMZ.
The default setting is "unchecked".
DMZ address Input the DMZ address (IPv4 address).
Apply button Apply the settings.
Cancel button Restore the previous settings
To Next Page
Loading...
