Furuno FELCOM251 - Page 198

APPENDIX 3 NOTIFICATION MESSAGES
Code Lvl BDU/Web UI Message Handset Message Explanation/Remedy
0x3840A E Diagnostic test for
Communication Unit
detects error (Flash
ROM).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (Flash ROM).Restart the
Communication Unit. If the problem persists,
contact your dealer.
0x3840B E Diagnostic test for
Communication Unit
detects error (FPGA).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (FPGA).Restart the
Communication Unit. If the problem persists,
contact your dealer.
0x3840C E Diagnostic test for
Communication Unit
detects error
(Temperature sensor).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (Temperature sensor).Restart
the Communication Unit. If the problem
persists, contact your dealer.
0x3840F E Diagnostic test for
Communication Unit
detects error (GPIO).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (GPIO).Restart the
Communication Unit. If the problem persists,
contact your dealer.
0x38410 E Diagnostic test for
Communication Unit
detects error (Ethernet
switch).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (Ethernet switch).Restart the
Communication Unit. If the problem persists,
contact your dealer.
0xB5400 W Diagnostic test for
Communication Unit
detects error (LED).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (LED).Restart the
Communication Unit. If the problem persists,
contact your dealer.
0xB5402 E Diagnostic test for
Communication Unit
detects error (PoE).
Diagnostic test
for Comm. Unit
detects error(s).
Diagnostic test for Communication Unit
detects error (PoE).Restart the
Communication Unit. If the problem persists,
contact your dealer.
0x20000105 W Login failed too many
times. System has
been locked.
Login failed and
locked.
It is locked because login failed many times
for a while.
0x20000106 W It has been locked out. It has been locked
out.
It is locked because login failed many times
for a while.
0x1100E W PoE disabled on LAN
port(s) due to power
limit.
PoE power limit. PoE disabled on LAN port(s) due to power
limit. Disconnect some PoE equipment from
LAN ports.
0x11008 E PoE overload is
detected.
PoE overload
detected.
PoE overload is detected. Disconnect the
PoE equipment from LAN ports and restart
the Communication Unit. If the problem
persists, contact your dealer.
0x11005 I PoE device which was
previously connected
has been
disconnected.
NA PoE device which was previously connected
has been disconnected.
0x11006 E PoE will be disabled
due to over/under
voltage.
PoE will be
disabled due to
over/under
voltage.
PoE will be disabled due to over/under
voltage. Restart the Communication Unit. If
the problem persists, contact your dealer.
0x1100C W Unable to feed PoE
power due to power
limit.
Unable to feed PoE
power due to power
limit.
Unable to feed PoE power due to power limit.
Disconnect the PoE equipment from LAN
ports and restart the Communication Unit.
AP-22