Naming the Device
You should enter a unique name for this device so you can easily identify it when viewing devices on the Fusion
PartyBus network.
NOTE: You should provide unique names to all of the devices and zones on the network to avoid confusion
when grouping, controlling, and setting up stereos and zones. You should also turn off zones that are not in use
(Speaker Zone Settings, page 24).
For further customization, you can provide unique names for the sources on each stereo and turn off unused
sources (General Settings, page 24).
1 Select > SETTINGS.
2 Select DEVICE NAME, and enter a unique name for the device.
Setting the Home Zone
The home zone is the speaker zone that you adjust by default when you turn the dial.
1 Select > SETTINGS.
2 Select ZONE > ASSIGN HOME ZONE.
3 Select a zone.
Selecting a Source
1 Select .
2 Turn the dial to highlight a source.
NOTE: If the device is part of a group, continue turning the dial to access the sources on other devices in the
group (Creating a Group, page 22).
If a source cannot be shared with the group, it will appear gray and you cannot select it.
3 Press the dial to select the source.
TIP: Alternatively, you can touch the source on the screen to select it.
Adjusting the Backlight and Dial Brightness
NOTE: If you connected the dim wire on the wiring harness to the boat's illumination wire, the backlight and dial
dim automatically when the boat lights are on. This may affect how you adjust the brightness setting.
1 Select > BRIGHTNESS.
2 Adjust the brightness level.
Audio Control
Adjusting the Volume
Using this stereo, you can control the volume of any zone on any stereo connected to the Fusion PartyBus
network.
1 Turn the dial to adjust the volume for the home zone on the stereo.
2 If necessary, press the dial to switch between zones.
NOTE: If this stereo is part of a group, you can adjust the volume of all stereos in the group or individual
zones on each stereo (Creating a Group, page 22).
Audio Control 5
To Next Page
Loading...
Need help?
General
