Setting a Static IP Address
If the stereo is configured as a DHCP server, it is automatically assigned the IP address of 192.168.0.1. You
can change this IP address.
If the stereo is a client on the network and you do not want the DHCP server to automatically assign an IP
address to the stereo, you can set a static IP address.
NOTE: Every device on the network must have a unique IP address. If you select a static IP address that is the
same as the IP address on the network, the devices will not work properly.
1 Select > SETTINGS > NETWORK > ADVANCED.
2 Select an option:
• If the stereo is connected using an Ethernet cable, select ETHERNET IP > STATIC IP.
• If the stereo is set as a wireless access point or wireless client, select WI-FI IP.
3 Select an option:
• To set the IP address, select IP, and enter the IP address.
• To set the subnet mask, select MASK, and enter the subnet mask.
NOTE: The subnet mask must match all other devices on the network to work properly. A typical subnet
mask is 255.255.255.0.
• To set the default gateway IP address, select GATEWAY, and enter the gateway IP address.
NOTE: The default gateway is typically set as the IP address of the DHCP server on the network.
4 Select SAVE.
Resetting Network Settings
You can reset all network settings for this stereo to the factory default values.
1 Select > SETTINGS.
2 Select NETWORK > ADVANCED > RESET > YES.
Update Options
Select > SETTINGS > UPDATE.
NOTICE
Do not turn off the device or disconnect the power during a software update. Turning off the power during a
software update may cause the device to become unresponsive.
NOTE:
• You can update the device software using a USB flash drive (Updating the Software Using a USB Flash
Drive, page 35).
• If the stereo is connected to a wireless network, you can update the software using the Fusion-Link app on a
mobile device (Updating the Software Using the Fusion Link App, page 36).
• The device may restart a few times when updating. This is normal.
• You can program only newer versions of software on the device.
STEREO: Updates the stereo using a valid software update file on a connected USB flash drive (Updating the
Software Using a USB Flash Drive, page 35).
NRX REMOTE: Updates an optional NRX remote connected to the NMEA 2000 port or NMEA 2000 network.
ERX REMOTE: Updates an optional ERX remote connected to the ETHERNET port or the Fusion PartyBus
network using a valid software update file on a connected USB flash drive (Updating the Software Using a
USB Flash Drive, page 35).
DAB MODULE: Updates an optional DAB module connected to the SIRIUS XM port.
FACTORY RESET: Restores all settings to the factory default values.
32 General Settings
To Next Page
Loading...
