Fusion Apollo MS-RA770 - Setting Device as Wireless Access Point

Wireless Access Point Settings
Select > SETTINGS > NETWORK > ADVANCED > WI-FI ACCESS POINT.
NOTE: You must configure the device to be a wireless access point before you can change the settings (Setting
the Fusion PartyBus Device as a Wireless Access Point, page 29).
SSID: Sets the SSID, or name, for the network.
AP SECURITY: Sets the type of wireless security protocol used by the access point.
NOTE: It is strongly recommended that you set the AP SECURITY using WPA2 PERSONAL. It is the most
widely-used and secure wireless security protocol.
PASSWORD: Sets the password for the access point. This is not available when the AP SECURITY setting is
set to NONE.
COUNTRY: Sets the region where the stereo is located. Different regions may use different channels on the
wireless spectrum, so you should set this to best accommodate local wireless devices.
CHANNEL: Sets the access point to use a group of channels in the high, low, or middle range of the available
spectrum for your region. You may experience better performance if you set the channel in a range with
fewer broadcasting access points.
DHCP SERVER: Sets the device to act as a wireless access point and the DHCP server on the network (DHCP
Settings, page 31).
WPS: Initiates a Wi‑Fi Protected Setup (WPS) connection. Devices with a WPS button or setting can connect to
the access point on this stereo when the WPS connection is active.
NOTE: It can take up to two minutes to successfully connect to the access point after you select WPS.
Advanced Network Configuration
You can perform advanced networking tasks on a Fusion PartyBus device, such as defining DHCP ranges and
setting static IP addresses.
Select > SETTINGS > NETWORK > ADVANCED.
DHCP CLIENT: Sets the device as a DHCP client. This is the default setting for all devices that are not
configured to be a DHCP server or wireless access point.
STATIC IP: Allows you to set a static IP address for the device (Setting a Static IP Address, page 32).
GARMIN MARINE NETWORK: Allows the device to be used on a Garmin Marine Network so it can be viewed
and controlled by connected Garmin chartplotters (Configuring the Stereo for use with a Garmin Marine
Network, page 31).
DETAILS: Shows information about the network configuration.
30 General Settings