DAB Playback
When you connect a compatible Digital Audio Broadcasting (DAB) module and antenna, such as the MS-
DAB100A to the Apollo RA770 stereo, you can tune in to and play DAB stations.
DAB broadcasts are not available in all regions. When the stereo is not set to a compatible region, the DAB
source is not available.
Setting the Tuner Region
You must select the region you are in to receive DAB stations properly.
1 Select > SETTINGS.
2 Select TUNER REGION.
3 Select the region you are in.
Scanning for DAB Stations
Before you can scan for DAB stations, you must connect a compatible DAB module and antenna (not included)
to the stereo.
NOTE: Because DAB signals are broadcast in select countries only, you must set the tuner region to a location
where DAB signals are broadcast.
1 Select the DAB source.
2 Select to scan for available DAB stations.
When scanning is complete, the first available station in the first ensemble found begins playing.
NOTE: After the first scan is complete, you can select again to re-scan for DAB stations. When the re-
scan is complete, the system starts playing the first station in the ensemble you were listening to when you
started the re-scan.
Changing DAB Stations
1 Select the DAB source.
2 If necessary, select to scan for local DAB stations.
3 Select or to change the station.
When you reach the end of the current ensemble, the stereo automatically changes to the first available
station in the next ensemble.
TIP: You can hold or to change the ensemble.
Selecting a DAB Station from a List
1 Select the DAB source.
2 If necessary, select to scan for local DAB stations.
3 Select > DAB > BROWSE > STATIONS.
4 Select a station from the list.
Selecting a DAB Station from a Category
1 Select the DAB source.
2 If necessary, select to scan for local DAB stations.
3 Select > DAB > BROWSE > CATEGORIES.
4 Select a category from the list.
5 Select a station from the list.
20 DAB Playback
To Next Page
Loading...
