FUTABA 10J - Page 107

107
Airplane
■ Activatingthefunction
①Selectthe"MIX"itemandthen
selectthe"ACT"bypressing
the+keyor‒key.
＋ −
or
● Whenyoudonotusea
function,settothe"INH"side.
■ Aileronrate
＋ −
or
②Select"RATE-AIL1"andoperatethe
aileronsticktotheleftandrightand
adjustthetravelofeachservoby
pressingthe+keyor‒key.
Range：-120 〜 +120%
Default：100%
● Whenyouwanttoreturnthesetvaluetotheinitialvalue,
pressthe+keyand‒keysimultaneously.However,when
thepolarityischanged,onlythenumberisreturnedtothe
initialvalue.
(The“RATE-AIL2”itemisadjustedinthesamewayas② .）
（Whenflaptrimisused,makethesettingsshownbelow.）
● However,setthebasictravelwiththeFlapfunctioninadvance.（Default：0%）
■ Flaprate
＋ −
or
③ Selectthe"RATE-FLP2"itemandadjust
theFlap2travelbypressingthe+keyor
‒key.
Range：-120 〜 +120%
Default：+100%
● Whenyouwanttoreturnthesetvaluetotheinitialvalue,press
the+keyand‒keysimultaneously.However,polaritydoes not
return.
（The“RATE-FLP1”itemisadjustedinthesamewayas ③ .
However,the“RATE-FLP1”sideinitialvalueis-100%.）
Flaperon
CH1
CH1
CH6
CH6
Whenflaperonisactive,the
aileronscanbecontrolledbythe
servosconnectedtoCH1andCH6.
Theservotravelcanbeadjusted
bytheleftandrightendpoints.
Theleftandrightaileronscan
beraised(brakeoperation)and
lowered(flapoperation)atthe
sametimebysettingSW-Ctoits
lowestposition.
FlaperonACT
AirbrakeACT